CPS-EP2000 Embedded & Wallmount PFC0,99

  • V programming with internal poti
  • OCP & OVP
  • Current Share Bus for N+1 parallel operation
  • Sense Mode
  • Current Monitoring
  • Remote Shutdown
  • Inhibit (Interlock)
  • DC & AC Power Good Relay open/center/close
  • Fan Monitoring
  • Temperature OT alarm
  • 6kW in a 2U & 10kW in a 3U subframe
  • Hard mount in 90° steps

Product Information (PDF)

 

 

 

CPS-EP2000

ModelCPS-EP2000
Continuous Power2000W
Nominal Input Voltage230Vac
Input Voltage Range AC184... 265Vac
Input Voltage Range DC250... 375Vdc
Input Frequency47... 63Hz
Hold-up Time30ms
Inrush Current AC14,6A RMS / 20,7A peak active electronic protection ±6%
StartautomaticSoftstart 100ms
Vout24V36V48V72V110V
Vout prog. with poti24-30V30-45V45-58V58-90V90-150V
Aout84A56A42A28A18,2A
Ripply & Boise mVpp35mV50mV75mV150mV300mV
Stability Loadswitch±0,05% 0-100%
Response< 1ms 10-100%
Effeciency92-94%
Power FaktorPFC 0,99
Load Free OperationContinuous
Short Cicuit ProtectionContinuous
Ambient Operations-20°C... +60°C
CoolingStepless controlled fans from EBM-Papst flow front-to-rear, Fan Fail Message
Temperature ControlPower reduction and message
Dimensions84x126,4x444mm, 2U or 3U Embedded or hard mount in 90° steps
IP HousingIP20
Safety IECEN60950-1 EN50178 EN60204-1
Safety Class 1(A)VDE0100 VDE0805
Input- /Output Isolation3000Vac
Climatic Calss, Humidity3k3, 90% non-condensing
EMIEN55022B
EMSEN61000-6-2,3
MTBF IEC61709500000h
Interface Current Monitoring0-5Vdc
Power Good RelayOpen/Center/Close
Sense Mode2V per load line
Remote ShutdownMessage
OptionsProtective coating
Accessory2U & 3U Frontpanel, 2U & 3U Subframe, Hard-Mount-Kit